Mirth Community

Mirth Community (http://www.mirthcorp.com/community/forums/index.php)
-   Support (http://www.mirthcorp.com/community/forums/forumdisplay.php?f=6)
-   -   x00-x7f Mirth Choke (http://www.mirthcorp.com/community/forums/showthread.php?t=221938)

StickyBandit 12-02-2019 10:39 AM

x00-x7f Mirth Choke
 
I noticed that Mirth MLLP port channels choke when there is a
Non-English Special Characters that are not in the Standard ASCII Table
x00-x7f

It doesn't do any good to put code to strip out the special characters, in the pre-processor, because mirth chokes at some place before the pre-processor is run.

Do the mirth programmers know anything about this yet?
Is there a setting that will fix this? Maybe changing the Encoding value?
(I tried a few and they didn't fix it.)

Mirth Connect Server 3.8.0
Built on May 22, 2019
Java version: 1.8.0_181

cory_cole 12-02-2019 10:40 AM

Try having the input at raw. Strip out the special characters. Then convert back to HL7.

agermano 12-02-2019 03:15 PM

It likely does have to do with the character encoding. It should match at both ends.

You probably have yours set to UTF-8 (also the linux default) if it's choking on anything higher than 0x7f.

The Windows default in the US is windows-1252 if you want to give that one a shot. It should at least process it, but you might end up with the wrong characters if that's not the right encoding.


All times are GMT -8. The time now is 09:20 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Mirth Corporation